Tannenbaum Scro, P.L.
Call For a consultation
941-444-9092 | 866-615-4543
Spanish Language Services Available


Guest Article by:

Felix Martin, P.E., Principal
Marcon Forensics
Orlando, FL

While inspecting the interior of a residential unit, you observe black mold growing on the walls. Is it a sign of poor housekeeping or of more serious problems? Should you consider vacating the unit immediately or ignore it altogether?

Mold infestation is a widely misunderstood malaise, both in terms of overestimating and underestimating its potential danger. Because of this, it is important once mold is encountered to properly assess its source and the remedial action to be taken.

What we know as mold, fungus and mildew are generally the same thing. It is nearly impossible to completely remove molds from the environment. Molds reproduce through microscopic spores that exist in the air around us. At low concentrations, mold and mold spores are not harmful to animals, but molds release allergens and at higher concentrations can produce allergic reactions that may vary greatly from person to person. Generally, young children, the elderly and people with respiratory problems should avoid touching mold or inhaling higher concentrations of mold spores.

When relatively mild, mold infestation may be cleaned with a solution of house chloride mixed with water. Excessive infestation may require removal by mold removal specialists. However, mold removal may be just treatment of the symptom and not a complete solution. Cleaning visible mold may not address the causes for the mold to exist and may prove a short-sighted and expensive misguided solution. 

For mold growth to occur, two things are needed: moisture and an organic food source. Mold growth on an interior wall generally uses the paper cover on the wall drywall as the organic food source. In a typically well conditioned interior air space, there is insufficient air moisture to encourage mold growth. Visible mold growth is a sign of excess moisture. If the source of excess moisture is not removed, simply cleaning the mold will not prevent its return. 

Sources of excess moisture vary. If mold growth is observed at the ceilings or near air conditioning air vents, the cause of the excess moisture may be the mechanical system. Perhaps the air conditioning system is not removing excess moisture or is not running correctly, or the clothes dryer is not properly exhausting moisture. 

Where mold is observed on wall areas near the bottom of exterior wall windows and doors, the excess moisture may be originating from rainwater leaking around the windows into the wall cavity. This is a much more troublesome problem in that if left unaddressed, may cause rotting of structural members inside the wall cavity, requiring extensive and expensive repairs.

If mold exists, it may be insufficient to call a mold removal company, as they generally treat the symptoms and not the disease. Particularly in cases where wall or ceiling mold has been removed and returned, it is important to contact a forensics firm to determine the source of the excess moisture. Only then can potential sources for the excess moisture required for mold growth be identified and an adequate remediation plan put in place.

No Comments

Leave a comment
Comment Information

Tannenbaum Scro, P.L.
1990 Main Street
Suite 725
Sarasota, FL 34236

Toll Free: 866-615-4543
Phone: 941-444-9092
Sarasota Law Office Map

Tannenbaum Scro, P.L.
214 S. Lucerne Circle
Orlando, FL 32801

Phone: 407-956-2184
Orlando Law Office Map

Tannenbaum Scro, P.L.
970 Lake Carillon Drive
Suite 300
St. Petersburg, FL 33716

Phone: 727-287-1018
St. Pete's Law Office Map

Tannenbaum Scro, P.L.
1415 Dean Street
The Dean Suites
Fort Myers, FL 33901

Phone: 239-215-4131
Fort Myers Law Office Map